·        Before using the ironing system, remove it completely from its packing case and packaging.

·        Put the item on a level and stable surface near a socket (max. Mt. 1,5).

·        It is recommended to keep the iron on the  non-inflammable carpet  supplied with the kit.

·        Insert the small metal staff (supplied with the kit) in point (2). Position the cable connecting iron and boiler.

·        In order to open the cap you have to press it down gently and at the same time screw it anticlockwise. When you press, the cap opens a valve that let the boiler steam come out. In order to screw it again (1) you have to press it gently.

·        Unscrew cap (1). Fill the boiler using the provided funnel with max. 2 Lt. of water. Make sure it does not spill over. 

·        Put the plug (6) into the outlet. Switch on boiler (4) and iron (3). If the two switches are lighted, it means that iron and boiler are working.

·        Turn the iron knob regulating temperature of iron plate  (7) to the position “cotton" °°° (as you find it on the iron knob).

·        Wait until the boiler warning light is out (4)  (after about 10 min.). While ironing, the light normally lights up by itself.

·        The system is ready to be used.

·        Press the steam button (8).

·        You can increase or decrease the steam released using the (9) steam knob.

·        If, while ironing, the steam stops and the water button (5) lights up, it means that the boiler water is almost out. In order to start ironing again, switch the boiler off (4), verify, by pressing the steam knob, that the iron does not release steam any more (8), switch it off (3), press carefully cap (1) so that the steam contained in the boiler comes out. Unscrew carefully the cap (1), before removing it, be sure that it does not release steam any more. Disconnect the plug (6) and then, after a few minutes, fill the boiler with warm water.

·        When you first press the steam button, after having turned the machine on, you might notice a decrease in pressure; this because the machine tubes are full of water. In order to have plenty of steam, wait until the button light is out.

·        Do not leave the machine unattended while the plug is in the socket.

·        Caution: the iron reaches very high temperatures and is still very hot even 15 minutes after you turn it off. So you might get burned, even if the system is switched off.  

·        The plug has to be pulled out before you fill the boiler with water. 

·        While ironing and until 15 minutes after the ironing, the iron plate is very hot and therefore dangerous- please, avoid touching it.

·        While using the machine do not unscrew or remove the cap. Before removing it, be sure that the brush does not release steam anymore. 

·        The machine has a special thermic device. Non qualified- people can not remove this.

·        The boiler cap must be replaced only with original parts.

·        If you need to let your ironing system be controlled or fixed, please contact only authorised technical assistance centres (for further information please call: tel. 0302141199 or visit our web site: www.lelit.com ).