·        Before using the ironing system, remove it completely from its packing case and packaging.

·        Put the item on a plane and stable surface near a socket (max. Mt. 1,5).

·        It is recommended to keep the iron on its non-inflammable carpet  (supplied with the kit).

·        Insert the small metal staff (supplied with the kit) in point (2). Position the cable connecting iron and boiler.

·        In order to open the cap (1), press it lightly down, and at the same time turn it anticlockwise. While pressing the button, a valve opens and releases steam from the boiler. In order to screw the cap, press it lightly and turn it clockwise.

·        Unscrew the cap (1). Fill the boiler with max. 2 Lt. of water using the supplied funnel. Make sure it does not spill over. 

·        Put the plug (6) into the socket. Switch on boiler (4) and iron (3). If the two switches are lighted, it means that iron and boiler are working.

·        Turn the regulation temperature knob of the iron plate  (7) to the position “cotton" °°° (as you find it on the iron knob).

·        Wait until the boiler warning light is out (4)  (after about 10 min.). While ironing, the light usually lights up by itself.

·        The system is ready to be used.

·        Press the steam button (8).

·        If, while ironing, the steam stops and the water button (5) lights up, this means that the boiler water is almost out.  In order to start ironing again, switch the boiler off (4), by pressing the iron steam knob   (8). Switch the iron off (3).  Verify, by pressing the steam knob, that the iron does not release steam any more, switch it off (3), unscrew slowly the cap (1), be sure, before removing it, that it does not release steam any more. Disconnect the plug (6) and then, after a few minutes, fill the boiler with water.

·        Do not leave the machine unattended while the plug is in the socket.

·        Caution: the iron reaches very high temperatures and is still very hot even 15 minutes after you turn it off. So you might get burned, even if the system is switched off.  

·        The plug has to be pulled out before you fill the boiler with water. 

·        While ironing and until 15 minutes after the ironing, the iron plate is very hot and therefore dangerous- please, avoid touching it.

·        While using the machine do not unscrew or remove the cap. Before removing it, be sure that the brush does not release steam anymore. 

·        The machine has a special thermic device. Non qualified- people can not remove this.

·        The boiler cap must be replaced only with original parts.

·        If you need to let your ironing system be controlled or fixed, please contact only authorised technical assistance centres (for further information please call: tel. 0302141199 or visit our web site: www.lelit.com ).